-
No Hub-SML Double short bend 88°
EN877 cast iron fitting double short bend 88°
EN877 чугунные арматуры двойной короткий изгиб 88°
degree： 88°
size： DN50-DN300
Standard： EN877
Material： Grey iron
Application： Construction drainage,pollution discharge,waste water rain water
Painting： inside and outside fully cross-linked epoxy,thickness min.60μm
payment term： T/T, L/C, or D/P
Production capacity： 1500 tons/ month
Delivery time： 20-30 days, depend on your quantity.
MOQ： 1*20 container
Features： Flat and straight ; high strength and density without defect;easy to install and maintain ; long lifetime ,fireproof and noise resistant; environmental protection -
Flange ring
A Ring Type Joint Flange is a type of flange that uses a metal ring that sits in a hexagonal groove as a gasket to seal the flange pair. The flanges seal when the bolts are tightened and the gasket is compressed into the groove making a metal to metal seal. -
No Hub-SML 45° Double Branch
Double branch.
45° between pipe and branches.
Designed in accordance with standard EN877，used for connection between pipes and pipes. -
No Hub-SML DS Offset Bend
DS CAST IRON Off-set
Cast Iron Fixed Offset Bend is available with a 130mm projection, and is used to direct a soil system around cornered obstructions, whilst keeping the system parallel. The bend is manufactured to EN877 using solid cast iron and finished with a Epoxy paint coating that complements the aesthetic of period buildings. -
No Hub-SML Cap with Rubber Seal
It is constructed of high quality cast iron. It is easy to install.
For use where a watertight seal is needed -
No Hub-SML 45°Single branch
Used to bring horizontal and vertical pipe runs together, usually when connecting a pipe from a WC into the main soil stack. The 135 degree angle introduces a steeper fall to the horizontal run than a standard 92.5 or 112.5 degree branch. It is most commonly found on the outside wall of a building, often on blocks of flats or apartments. -
No Hub-SML 88°Large Radius Bend with Access Door
SML 88°Large Radius Bend with Access Door, foul and surface water drainage system
Includes a wide variety of components, such as Bends, Junctions, Rodding Access and Access Fittings, together with Inspection Chambers and Manhole Bases.
-
No Hub-SML 88°Large bend
Cast Iron SML 88°Large bend
Cast Iron SML is a dry-jointed, lightweight cast iron drainage system, primarily used for above ground soil and waste drainage but also for rainwater installations
High strength, low maintanence system
Quick to assemble
Agrement EN 877 -
No Hub-SML Top bend
EN877 SML Top bend
Material: Grey Cast Iron
Coating: SML,KML,BML,TML
Product description：The pipe fittings have smooth surface, high density and strength, reasonable design in structure, beautiful externality used on high buildings and environmental protecting. -
No Hub-SML Vent bend
SML Vent bend
Material: Grey Cast Iron
Coating: SML,KML,BML,TML
Product description：The pipe fittings have smooth surface, high density and strength, reasonable design in structure, beautiful externality used on high buildings and environmental protecting.
-
No Hub-SML 45°Bend
Cast Iron SML 45°Bend Cast iron
Cast Iron SML is a dry-jointed, lightweight cast iron drainage system, primarily used for above ground soil and waste drainage but also for rainwater installations
High strength, low maintanence system
Quick to assemble
Agrement EN 877 -
floor drain
A floor drain is a plumbing fixture that is installed in the floor of a structure, mainly designed to remove any standing water near it.
Floor drain DN200*100